Echelon NodeBuilder Errors 3120 User Manual download pdf (Page 103)

NodeBuilder Errors Guide 6-11

NEX# Description

4005 Ignoring superfluous .phd file (<filename>) [NEX#4005]

Ignoring superfluous .phd file. Both a new and a legacy linker

dependency file have been specified; the old format (.phd) is being

ignored.

4006

The selected feature requires exporting a configured image

(feature ignored) [NEX#4006]

A feature was requested that can only be used with a configured

image; use the --state command to request exporting of a

configured image.

4007

Cannot update dependency file <file> (<reason>). This might

cause the build status calculator to fail [NEX#4007]

The Exporter's dependency file cannot be written due to the reason

given in the message. The file should be made writable to prevent

the build status calculator from failure.

4008

No boot ID was specified. A random value (<value>) is being

used instead [NEX#4008]

A boot ID value was not explicitly specified. To prevent multiple

versions of the same device to be exported with the same boot ID,

the Exporter automatically allocates a boot ID randomly (value

shown in the message). It is recommended to use the --bootid

command to explicitly specify the desired boot ID value, or to use

the Project Make Facilities' boot ID management feature.

4009

The export configuration does not permit the authentication

key, domain ID, subnet ID, or node ID to be set. These will be

ignored and the image will be exported in the requested

state [NEX#4009]

The image cannot be exported in the desired state with all data

provided. Superfluous data is being ignored, as the state has

priority over the other parameters. For example, this could occur

if an image is to be exported in a 'no domain' configuration

although a domain ID has been specified.

4010

The subnet/node ID has not been specified for the desired

configuration. S/N = 1/1 is assumed [NEX#4010]

This warning will occur whenever an image is to be exported into

the cloned domain, without both subnet and node ID being given.

A device that has the clone domain flag raised must still have a

valid domain/subnet/node configuration. The warning indicates

that the problem has been recognized, subnet/node ID 1/1 are

being assumed, and the export continues.

Make sure to verify that this assumption meets your

requirements.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 122 123

Comments to this Manuals

No comments

Echelon NodeBuilder Errors 3120 User Manual Page 103

Comments to this Manuals

Related products and manuals for Networking Echelon NodeBuilder Errors 3120