Echelon NodeBuilder Errors 3120 User Manual download pdf (Page 8)

1-2 NodeBuilder Debugger Errors (DBG)

DBG# Description

1 No error [DBG#1]

2 Memory allocation failed [DBG#2]

Save your work and restart the system

3 Cannot open a needed file [DBG#3]

Clean, rebuild, load and restart the debugger.

4 Invalid DBT file format or DBT file is corrupt [DBG#4]

Clean, rebuild, load and restart the debugger. If this persists

you may need to re-install NodeBuilder.

5 Communication to network interface failed [DBG#5]

This may happen when starting the debugger. Use the control

panel or LonMaker to test the Network Interface.

Cannot communicate with the device over the network

[DBG#6]

Make sure it is connected and any intervening routers are

configured and online.

7 Cannot find the requested symbol [DBG#7]

Re-enter the symbol name. The DBT file might be out-of-date.

Source line translates to less than 2 bytes of object code,

so a breakpoint cannot be placed here [DBG#8]

In the NodeBuilder’s Device Template Editor, check the

“Expand statements” item and re-build if you really need to

set a breakpoint at this location.

Object code at breakpoint is not in writable memory, so

a breakpoint cannot be set [DBG#9]

NodeBuilder debugger modifies program memory when it sets

breakpoints.

10 No instruction for BP at this location [DBG#10]

Make sure the build status is up-to-date. Try closing and re-

opening the source file.

Command only legal when debugger is not suspended,

not currently used [DBG#11]

No longer used.

Command is only legal when debugger is suspended,

e.g., Neuron remote procedure calls [DBG#12]

Remote procedure calls are not supported.

13 Failed in file read/write [DBG#13]

The target hardware did not complete the operation.

Out case reached -- should be development only

[DBG#14]

Not used in release builds.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 122 123

No comments

Echelon NodeBuilder Errors 3120 User Manual Page 8