Echelon NodeBuilder Errors 3120 User Manual download pdf (Page 109)

NodeBuilder Errors Guide 7-5

PMK# Description

132

Cannot read the hardware platforms database <file>.

[PMK#132]

Make sure the platform’s database file <file> exists. The default

location for this database file is

\LonWorks\NodeBuilder\Templates\Hardware\nbplatforms.xml

133 Library <lib> is required but cannot be found [PMK#133]

The Project Make Facility has aborted the build process because a

library <lib> is required, but cannot be found.

4001

An empty program ID has been specified. It is recommended

to change the program ID, using the device template editor

[PMK#4001]

An empty program ID, i.e. a program ID without a value, has been

specified. It is recommended to change the program ID, using the

device template editor. This might result in a compilation failure.

This message should not occur when using a machine-generated

device template file.

4002

The configured program ID results in an unstable build

status, and may not suitable for automatic management. It

is recommended to reconsider the specified program ID, or to

disable program ID management. This might lead to a

failure in the remaining build process [PMK#4002]

This message indicates that program ID management causes an

unstable build status. This loop condition has been detected after

three fix-up compilation attempts, and the fix-up attempts have

been aborted to prevent an endless loop condition. A fix-up

compilation might occur as a result of automatic program ID

management, where the PID manager detects an interface change

after the initial compilation, where the interface change impacts

the compiler's DRF lookup. Thus, a re-compilation is attempted

with the new program ID, and in this particular case, the problem

persists. This effect might be caused by the combination of

automatic program ID management and a DRF scope value 6. This

combination is not recommended for use in NodeBuilder 3, because

program ID management modifies the model field, and the scope 6

resource file expects the model field not to change.

4003

Can't write file <make dependency file>. This might cause

the build status calculator to malfunction, but does not

impact the build results (system error code <code>)

[PMK#4003]

Failure to write a .nkdep dependency file. Insufficient write-

permission, or a write-protected media could cause this effect. This

failure does not harm the build itself, but causes the build status

calculator not being able to determine the build status correctly.

Solution: make .nkdep file writable, or disable automatic program

ID management.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 122 123

Comments to this Manuals

No comments

Echelon NodeBuilder Errors 3120 User Manual Page 109

Comments to this Manuals

Related products and manuals for Networking Echelon NodeBuilder Errors 3120